beautypg.com

Contr ol s & i ndi cator s – Seaward B433R User Manual

Page 11

background image

General Guidance Notes

11

FIG.1 Facia Controls & Indicators


Contr ol s & I ndi cator s

1. Supply Switch

– ON / OFF rocker switch, illuminated in the ON position.

2. Earth Circuit meter

– displays the ohmic value of the measured Earth path.

3. Set Zero control

– (unmarked hole below meter) used to set mechanical zero of the meter during factory build

& calibration procedures. User adjustment not normally required.

4. Set Inf. control

– screw-driver adjuster used for setting the full scale (INF) reading of the meter to

compensate for mains fluctuations, or differences, from location to location. Refer to Set-Up procedures.

5. Probe Socket

– for connection of the special ‘no-burn’ test probe (see accessory illustrations overleaf).

6. Clip Socket

– for connection of the ‘earth return’ clip lead.

7. Cable Compartment –

(situated on rear of instrument)

for storage of test and supply leads when not in use or

during transit.

8. Supply Inlet Socket –

(on rear panel, within cable compartment) for connection of the mains supply lead.

9. Tilt Feet –

the instrument case can be tilted, to improve the viewing angle, by setting the front feet to their

forward, upright, position.

10. Grab Handle –

used for carrying the instrument. Can be swung to top or bottom when not in use.