Sea Eagle Stealth Stalker 10 (STS10) - Manual (Page 6)

Deluxe Fishing Seat
(OPTIONAL)
The Deluxe Fishing
Seat (DFS) has two in-
ternal bladders, two
valves and two straps.
Tether the valve to the
valve base., Stretch the
ring over the base. The
ring fits in a groove in
the base.
TIP: Soak valve caps in
warm water to make in-
stalling the ring over the
base easier.
Pump Nozzle
This triple nozzle
adapter comes with the
foot pump and is
needed to inflate the
deluxe one-way air
valve on the DFS. Insert
the ribbed end of the
large rounded adapter
piece into the hose.
Unscrew the cap and
screw the valve in tight
to prevent air from leak-
ing during use. Inflate
the seat using the foot
pump with the adapter
above.
Lay out the canopy
parts on the floor.
Arrange the canvas top
side up and fold ends
back as shown here.
Position the curved bars
so the locking holes at
the ends are up. The
sleeve with a window
cut-out is the front.
Push the tube through
the front sleeve until it
shows in the window.
Place the strap loop
over the tube and finish
inserting the tube. Insert
the other tube in its
sleeve.
Flip the front bar over
and insert the side rods
into the curved tube.
The short rod goes into
the front tube. There are
buttons to lock the
tubes together.
Stow Bag
Remove the male clips
from the mounting pads
on the boat. Push the
end of the strap up
through the middle of
the male clip and down
through the slot in front
as shown.
5
ONE TIME ASSEMBLY (continued)