Sea Eagle Stealth Stalker 10 (STS10) - Manual (Page 10)

Insert the valve adapter
into the valve and turn it
to lock the hose in
place. If using the foot
pump, inflate each
chamber until it is very
firm. You cannot over in-
flate with the foot pump.
Your STS-10 holds a lot
of air. We suggest one
of our electric pumps
such as the BTP Mano,
shown here, to speed
the inflation process.
While inflating, check
that the floorboards are
fully seated.
Swivel Seat
(OPTIONAL)
Slide the base of the
pedestal into the seat
mount until you hear it
lock. To remove, lift the
tab and slide out.
Deluxe Fishing Seat
(OPTIONAL)
If you have the inflat-
able seats, they can be
arranged anywhere in
the boat.
Scotty Rod Holders
Push the rodholder into
the mount. The key
must be aligned with the
groove in the base.
The rodholders can be
rotated by lifting slightly,
rotating to desired posi-
tion and pushing down
to lock in place.
Stow Bag
Insert the male clip into
the female part installed
on the boat.
Oars
Assemble the oars and
secure them to the oar-
locks. Unscrew the ball
from the oar pin and in-
sert the oar through the
hole. Replace the ball
and loop the shaft into
the velcro holder. Your
Sea Eagle is ready for
launching.
9
ASSEMBLY & INFLATION (continued)