Sea Eagle Sport Kayak (SE 330, SE 370) - Manual (Page 6)

Assembly & Inflation
To begin unroll your
boat on a clean, flat
surface. Locate the
three main air chambers
in the stern and screw
the deluxe one-way air
valves to them. Make
sure not to cross the
threads when screwing
in the valve to the base
or when tightening the
outer cap.
Printed on the inside of
your kayak is a diagram
of the plastic inflation
monitor that is included
with this boat. As you
begin to inflate, the hull
material will stretch so
that the printed diagram
will expand to match the
clear plastic inflation
monitor.
Inflate the three main
chambers of the hull
and the bow and stern
spray skirts. You can
safely inflate up to 1
centimeter beyond the
diagram. When the boat
is fully inflated you
should be able to indent
your thumb into the ma-
terial about 1/2 to 3/4 of
an inch.
Drain Valve
Featured on the rear of
your Sport Kayak is a
self bailing drain valve.
If you are planning to
use your boat on calm,
flat-water you should
close the drain valve. If
you are planning to use
your boat on rapids or
surf, you should open
the valve as shown.
Assembly & Inflation
SEC Inflatable Seat
The SEC seat inflates
using two deluxe one-
way air valves. Once
the seat is inflated you
can simply place inside
of the boat. The seat is
held in place by the
weight of the user and
the pressure from the
surrounding tubes.
Deluxe Inflatable Seat
The deluxe inflatable
seat inflates using two
deluxe one-way air
valves. Inflate the seat
so that its reasonably
hard. You can also
change the center of
gravity by letting a bit of
air out of the bottom
portion of the seat.
If you’re paddling solo,
position the seat just aft
of the mid-point of the
kayak. If you’re paddling
tandem, position the
rear seat as far back as
possible and the front
seat slightly forward of
the mid-point of the
kayak.
Carry Bag
This 440 Denier Nylon
carry bag measures
26”x48” and is great for
the transportation of
your Sea Eagle. Comes
with convenient carry
strap and drawstring.
5