Scotsman MDT3F - Manual (Page 6)

Wall Mount Kit (KWB4):
Contents:
1. Top Case Hanger Bracket: Attaches to the frame
of the dispenser.
2. Top Wall Bracket: Mounts to the wall and
engages the top case hanger bracket to support
the dispenser.
3. Bottom Wall Bracket: Mounts to the wall and
spaces the base of the dispenser away from the
wall.
4. Bottom Fittings Cover: Fastened to the bottom
wall bracket to hide the utility connections.
5. Junction box cover.
Installation: Check building wall for the strength
required to support a machine of this weight and
size. Note that if at least 6" of space is not left
above the machine, cleaning and most service of
the machine will require removal of the machine
from the wall mounts. All utilities are to be routed
thru the base. The back panel is not used when
the machine is hung from the wall.
Top Case Hanger Bracket
1. Remove back panel.
2. Place top hanger bracket on the inside of the
frame and position it in line with the pre-punched
holes in the frame.
3. Fasten the bracket to the frame with four ¼ - 20
screws from the kit.
Top Wall Bracket:
1. Hold the bracket on the wall where it will be
mounted.
2. Mark on the wall the positions of the holes in the
bracket.
3. If needed, drill pilot holes for the fasteners.
4. Secure the bracket to the wall with fasteners of
sufficient strength to hold up the dispenser.
Connect all internal utilities. Route tubes and
wires out the bottom.
Junction box cover. Install on the junction box.
Bottom Wall Bracket:
1. Lift up and hang the dispenser from the top wall
bracket.
2. Position the bottom wall bracket so that the
molding on the dispenser base bottoms in the
channel of the wall bracket.
3. Secure the bracket to the wall.
Bottom Fitting Cover:
1. Connect electrical power, water inlet, bin drain
and sink drain of the dispenser thru the bottom of
the case.
2. Secure bottom fitting cover to the bottom wall
bracket with the four sheet metal screws provided
in this kit.
MDT3F & MDT4F
May 2001
Page 6
1
2
3
4
5
Wall
Brackets
Secure With
Screws
Bottom
Cover
Top Case
Bracket