Ice level controls – Scotsman HID312 Service Manual User Manual
Page 19
HID312, HID525, HID540
Service Manual
April 2015
Page 19
Ice level controls
Clean if the controller indicates bin full and there
is no ice between the sensors.
1. Remove top front and top panels.
2. Shut machine off.
3. Disconnect ice level controls at connector.
4. Remove 3 screws and ice storage bin cover.
5. Pull each sensor grommet clip up and off.
6. Push grommets out of bin top.
7. Pull each sensor out of its rubber grommet. Pull
on the part closest to the grommet, not the wire.
8. Wipe the sensor lenses clean with a soft, clean
cloth. Caution - do not scratch the lens. If there
is mineral scale on the lens, ice machine scale
remover will be needed to wipe them clean.
9. Return each sensor to a grommet, push it in until it
snaps into place.
10. Reverse the rest of the steps to reassemble.
Cover
Clip
Sensor
Grommet