Royal Cozyfires Slimline Standard MK2 - LPG - Manual (Page 12)

MM79 010710
2.4.4.2 INSTALLING THE APPLIANCE (Fitting the firebox in the opening) Slimline Standard MK 2
There are two options to fit the firebox into the opening:-
Prior to fitting the firebox, fit the foam seal provided. It should be positioned approximately 10mm from the outside edge of the
metalwork. This ensures maximum flow of air through the fire flue. There are two options to fit the firebox into the opening:-
Fix four `screw eyes’ to the rear of the opening. (Note the minimum and maximum height restrictions in the diagram above). Thread
the wire cable downwards through the two holes located on the lip of the flue outlet. Thread through the top two `screw eyes’ and then
through the bottom two `screw eyes’. Finally thread through the two holes located at the rear of the firebox.
Pull the wire cable and carefully push the firebox into a central position in the opening. Thread each end of the wire cable through the
adjusting screw and then through the retaining bush. Adjust the cable and tighten the retaining bush to ensure that a good seal is
made between the firebox and back panel.
Page 11
Fig. 17
OPTION 1 WALL FIXING
Offer the firebox into the opening. Mark the holes
provided, (indicated by the four arrows in Fig. 17), drill,
plug and screw the firebox to the back panel, ensuring a
good seal is made between the firebox and back panel.
OPTION 2 WIRE CABLE FIXING
This method is for when it is undesirable to deface or
risk damage to the surround (Fig. 18).
Fixing hole
Fixing hole
Fixing hole
Fixing hole
Cable fixing holes
Adjusting screw
Retaining Bush
Flue outlet
Screw eye
Min Height
150mm
Max Height
300mm
160mm apart
Four `screw eyes’ are fixed to the
rear of the opening with wall plugs.
Min height from base of opening–
150mm
Max height from base of opening–
300mm
`Screw eyes’ to be 160mm apart
Fig. 18