3 quick start procedure – Research Concepts RC1000 User Manual
Page 11
RC1000A Antenna Controller............................................................5.0 Quick Start 9
5-3 QUICK START PROCEDURE
1.
Install unit. (Refer to Section 4.)
2.
Set EAST limit - This value will be assigned a value of 10 after the west limit is set.
(Section 6-5.)
3.
Set WEST limit - This value will be assigned a value of 980 to normalize the count for
display format consistency. (Section 6-5.)
4.
Set SLOW and FAST speed indexes according to the antenna load and application. The
system defaults are 11 for slow and 23 for fast. (Section 6-9.)
5.
Validate clear memory - "NO DATA" in AUTO Mode.
6.
Jog to easternmost satellite in MAN mode.
7.
Assign position to satellite name and set polarization. (SET mode - Section 6-6.) If skew
keys don't seem to work, make sure that Auto-Pol is disabled. (Section 6-10.)
8.
Manually jog WEST to next satellite.
9.
Repeat 7 & 8 for all satellites desired.
10.
Check positioning accuracy with AUTO mode. (Section 6-4.)
11.
Enable AUTO-POL feature if the RC1000A is slaved to a receiver. (Section 6-10.)