Remotec ZRC-100 V1.47 - Manual (Page 25)

25
9
Press f key to confirm
to clear the selected
scene or
Press e key to cancel it
and go back to previous
page.
Note 1: ZRC-100 supports up to 16 characters in a row for the scene
name.
Note 2: This process will only remove the scene devices/EPs from its
assigned scene but will not exclude it from the network.
Note 3: The above steps are needed if ZRC-100 to be a secondary
remote controller and the Scene information mapping from gateway /
primary controller is unsuccessful.
Comfort / Sensor Configure
It is allow to Move/Rename/Delete the device after added into the
network under the Comfort / Sensor Configure function.
Step Setup Key LCD Indication
1
Press and hold ef keys
simultaneously for 3
seconds under the Home
page.
⇓
2
Select “Comfort
Configure＂and press
key.
Clear
Scene 1
e NO Confirm? YES f
Home
Device >
Scene >
Comfort >
OK to Enter
Setup
Add Device >
Delete Device >
Add to Scene >
OK to Enter
Setup
Comfort Config. >
Sensor Config. >
Shortcut Key >
OK to Enter