Remotec ZTS-110 V3.12 User Manual

Page 30

Note:
- It is recommended to perform the Delete/Exclude procedure before doing

Add/Include. This is to make sure the ZTS-110 is not in any other Z-Wave
network which will result in failure in Inclusion process.

- If the inclusion is failed, try exclusion, and/or reset ZTS-110 to factory default and

try inclusion again.

- After ZTS-110 is included to Z-Wave network, it will stay in Easy mode by default.
- You can enable or disable Easy mode by local "Setting Mode" or Z-Wave

parameter number 8.
(please refer to parameter table at Z-Wave Configuration Parameters).

LCD indication

Step

Procedure / Description

Gateway / Controller device should be set
to inclusion mode.
Press and hold "Home" key for 2 seconds
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.

Press "Prog" key once, it will search the
network.

If the ZTS-110 is added into the network
successfully, the signal of "done" will
appear.

Press "Home" key once to go back to the
home page.

will appear on the main display.

WAKE

PROG ON

COOL

FAN AUTO