REMKO Elektric Booster Heater - Manual (Page 9)

9
Diagram of the unit
Protective cap
Seal
Heating resistors
Thermostat
STB (inside)
The equipment and components are manufactured using state-of-the-art production
methods and tested several times to verify their correct function. If malfunctions
should occur, please check the functions as detailed in the list below. Please inform
your dealer if the unit is still not working correctly after all the functional checks have
been performed!
Troubleshooting and customer service
Fault Possible cause Checks Remedial measures
Water in tank does
not heat up
Circuit breaker
has tripped
Is the breaker in
the distributor still
switched on?
Switch back on
Safety temperature
limiter (STB) was
activated
Has heater over-
heated?
Reset STB, check tank
temperature
Temperature control
wrongly set
Is the temperature
control adjusted to
the right setting?
Adjust the temperature
control to the desired
operating temperature
Diagram of the unit