REMKO Elektric Booster Heater - Manual (Page 3)

3
Description
The electric booster heater is installed as
an auxiliary heater in the storage tank.
It consists of a high-quality tubular
heating element, which is fitted on to
a 1 1/2" external thread.
They are intended for the pressure-tight
operation and heating of heating water.
They are distinguished by requiring no
care or maintenance and being easy to
operate.
The max. temperature can be set on the
thermostat. The 6 kW heater is switched
on by the heat pump manager and,
after the desired water temperature is
reached, back off again. If the water
temperature falls, e.g. due to extremely
low outside temperatures, then the
unit's heater switches back on until the
set water temperature is reached.
■ 1 pc. Protective current discharge
resistor
■ 1 pc. Temperature sensor
■ 1 pc. Safety temperature limiter
■ 1 pc. Thermostat control
Scope of delivery
Environmental
protection and recycling
Disposal of packaging
All products are packed for transport
in environmentally friendly materials.
You can make a valuable contribution
to reducing waste and sustaining raw
materials by only disposing of packaging
at approved collection points.
Disposal of
components
The manufacturing process for the units
is subject to continuous quality control.
Only high-grade materials are processed,
the majority of which are recyclable. You
can also contribute to environmental
protection by only disposing of
components in accordance with local
regulations and in an environmentally
safe manner, e.g. through authorised
disposal and recycling specialists or at
collection points.
Intended use
Depending on the model, the units and
the additional fittings with which they are
equipped are only intended to be used as
an air-conditioner for the purpose of cooling
or heating the air in an enclosed space.
Any different or additional use shall
be classed as non-intended use.
The manufacturer/supplier assumes no
liability for damages arising from such use.
The user bears the sole risk in such cases.
Intended use also includes working
in accordance with the operating
manual and installation instructions
and complying with the maintenance
requirements.