REMKO CMF-80 v.1 - Manual (Page 5)

Temporary
Decommissioning
If the heating plant is not to be
used for heating purposes over
an extended period (e.g. during
a period of absence), the plant
may not be disconnected from the
mains!
■
During the decommissioned
period, the plant must be set to
"standby" mode.
■
Heating programs can be
programmed for the duration
of a period of absence (see also
"Changing the timer programs"
section).
■
When the decommissioned
period is to be ended, the mode
should be changed back again.
■
Changing the mode is described
adjacently.
In "standby" mode, the heat
pump is "switched off".
However, the frost protection
function remains active at all
times on the entire plant.
NOTE
Changing the modes
Press the bottom-most F
button next to mode
(in example "standby").
Set the desired mode
with the rotary knob.
The selected mode is
confirmed by pressing
the F button next to OK.
The standard display is
shown.
Mo 22 Sep 08 08:30
T-external 15.3 °C
T-collector 36.2 °C
Standby
Mo 22 Sep 08 08:30
T-external 15.3 °C
T-collector 36.2 °C
Automatic 1
Mode
End
Standby
Standard
OK
Mode
End
Automatic 1
Standard
OK
5