REMKO PWW 5000 - Manual (Page 4)

4
Assembly Instructions
Follow these instructions to ensure that the units are
assembled safely and effectively:
◊ The heat-exchanger must be connected in such a
way that vibrations from the unit may not be trans-
ferred to the piping systems or vice-versa.
◊ Before connecting the unit to an existing warm water
heating system, the boiler and pump must be
checked for adequate capacity.
◊ For maintenance and repairs, we recommend at-
taching a repair switch close to the unit.
◊ After all attachment screws have been tightened
evenly, the fan is to be checked to ensure that it is
running smoothly.
◊ The permissible assembly heights must be ob-
served.
The minimum permissible distances from the floor to
the lower edge of the unit can be found in the table
in the section on unit assembly.
Unit Assembly
The units are intended for assembly under the ceiling.
Adjustable assembly profiles make it possible to adjust
the units easily to suspended ceilings as well.
The units are attached directly under the ceiling or with
assembly profiles that can be purchased as accessories.
The permissible assembly heights must be observed.
Assembly options:
A: Aligned under the ceiling B: With a fixed assembly profile
(Dimension x = 40 mm)
x
C: With adjustable assembly profile
(Dimension y = 150 - 250 mm)
y
Recommended max. assembly
height:
Distance from floor
to lower edge of unit
PWW 5102 2,3 m
PWW 5202 2,4 m
PWW 5402 2,6 m
PWW 5602 3,3 m
Safety Instructions
Extensive tests have been conducted on the material,
functionality and quality of the units.
Hazards may nevertheless arise if the unit is used by
persons not familiar with its operation or if the unit is not
used for its intended purpose.
Please make sure to always comply with these safety
instructions:
◊ The relevant local building codes must always be
observed!
◊ The operator is responsible for proper unit assembly,
correct electrical installation and safe operation of the
units.
◊ The units must be set up, mounted and operated in
such a way that employees are not bothered by or
put at risk of radiant heat.
◊ The units may only be attached to sturdy construc-
tions or ceilings made of materials with adequate
bearing capacity.
◊ The units must be attached with sturdy wall mounts
that are fastened to the unit.
◊ Assembly, connection of the heating medium, con-
nection of the electrical system and maintenance
may only be performed by trained and authorised
personnel.
◊ The units may not be set up, assembled or operated
in surroundings susceptible to fire or explosions.
◊ The units must be set up outside of high-traffic
zones, e.g. also cranes.
A safety zone of 1 m must be maintained.
◊ The units may only be operated when mounted.
◊ Safety components such as, for example, protective
grilles, may not be disassembled or taken out of op-
eration.
◊ The units may only be used for their intended pur-
pose within the specified operating ranges and with
approved transport media.
See type plate.
◊ The air intake grille must always be kept free of dirt
and loose objects; the unit outlets may not be
blocked.
◊ Never insert foreign objects into the unit.
◊ The units may not be exposed to a direct stream of
water.
◊ Never let water get inside the units.
◊ All of the unit‘s electrical lines must be protected
from damage, e.g. by animals.
The units are only ensured to function properly if
the initial temperature in the unit supply lines and
the pump capacity are adequate for the selected
class of unit.
*
re
co
m
. m
ax.
a
sse
m
bly
h
e
ig
ht