Remko asf 100 – REMKO ASF 100 User Manual
Page 8
8
REMKO ASF 100
3. Carefully place the emptied con-
densate container with closed
slider in the unit.
The “Tank full” indicator light
extinguishes and the unit contin-
ues to operate fully automatically.
Continuous operation with exter-
nal condensate connection
The condensate containers are
provided with a special connection
at the back.
After removing the sealing plug,
a suitable drainage hose can be
connected.
Connection external
diameter = 11mm
Empty condensate container
The installed condensate container
must be emptied from time to
time.
When the condensate container is
full, dehumidification is interrupted
with the generation of an audible
signal.
The “Tank full” indicator light
shows that the unit has switched
off.
1. Carefully pull out the full tank.
2. Open the slider in the corner of
the container and pour out the
water into a drain.
NOTE
After each emptying, the
condensate container including
float switch must be checked
for possible damage, fouling,
etc.
IONISER
The unit has an ioniser genera-
tor for the generation of negative
ions.
A high concentration of negative
ions occurs, e.g. in mountainous
regions, at waterfalls and in forests
and the air we inhale is „pure“.
Only a small ion concentration is
present in rooms.
Here, the ion generator is able to
enrich the oxygen molecule ions
in the circulated air and provide a
pleasant atmosphere.
Also, suspended and dust particles
in the air are bound so that natural
air purification can take place.
As a result of ionisation, the dust is
able to deposit on smooth surfaces
and removed manually.
This function is active in all modes
after selection.
TIMER
This button is used to program a
decremental switch off timer. The
timer can be set to 2, 4 or 8 hours
by pressing the button repeatedly.
Pressing the button again switches
off the timer.
NOTE
The housing and filter clean-
ing intervals reduce when
using the ioniser.
NOTE
The unit will only start with
a correctly fitted condensate
container.
NOTE
Also when using an external
condensate hose, the conden-
sate container initially fills up
to the level of the connection
before condensate discharges
from the hose.