REMKO ASF 100 - Manual (Page 10)

10
REMKO ASF 100
4. Clean the air inlet grille with
warm water or a vacuum
cleaner.
5. A heavily clogged grille with
filter can be washed in a warm
soap solution (maximum 40°C).
Subsequently rinse thoroughly
with clear water and allow to
dry!
6. It must be ensured that the grille
with filter is completely dry and
undamaged prior to refitting.
NOTE
Heavily fouled or damaged air
inlet grilles must be replaced
with new ones.
Only original spare parts must
be used.
Filter cleaning
The unit is provided with an inte-
grated air filter to prevent damage.
To prevent a reduction in
performance and faults, the air
inlet grille with filter must be
checked as required, however at
least once a week and cleaned if
necessary.
1. Switch off the unit with the
button. Note the after-running
time!
2. Disconnect the plug from the
power socket.
3. Pull the air inlet grille out of the
unit at the recessed grip [G].
ATTENTION
The units must not be used
without air inlet grille fitted!
G
All moving parts are provided
with low-maintenance permanent
lubrication.
■ Observe regular care and main-
tenance intervals.
■ Depending on the particular
operating conditions, the units
should be tested by an expert
for reliable operation as neces-
sary, however at least once a
year.
■ Only clean the units dry or with
a moist cloth
Do not use a jet of water!
■ Do not use caustic cleaning
agents or those containing
solvents.
■ Only use suitable cleaning
agents to remove heavy
fouling.
■ Regularly check the air inlet and
outlet grilles for fouling.
Clean or replace if necessary!
Care and maintenance
NOTE
Regular care and maintenance
is a basic precondition for a
long useful life and trouble-
free operation of the unit.
ATTENTION
Before carrying out all work
on the units, the mains plug
must be disconnected from the
power socket.