REMKO ASF 100 - Manual (Page 4)

4
REMKO ASF 100
Unit description
Operation
The units can be switched on and
off with the ON/OFF button.
The LED of the last selected mode
lights up in the control panel.
The recirculation fan draws in the
humid room air via the inlet grille
with filter, condenser and follow-
ing adsorption rotor.
In the internal regeneration circuit,
the air flows across a heating ele-
ment, dries the adsorption rotor
and passes the humid air through
the condenser.
On the cooler condenser, heat is
removed from the room air and
cooled to below dew-point. The
water vapour contained in the
room air deposits as condensate.
Depending on the room air tem-
perature and relative humidity,
the condensed water constantly
drips through the integrated drain
connection into the condensate
container located below.
The conditioned drier air continu-
ously mixes with the room air. Due
to the constant circulation of the
room air through the unit, the
relative humidity in the room is
gradually reduced to the required
humidity (45% relative humidity).
A float switch in the condensate
container interrupts dehumidifica-
tion via a microswitch when the
container is full. The units switch
off with an audible signal
(5x) and the „FULL TANK“ indica-
tor light illuminates on the control
panel. This does not extinguish
until the emptied condensate con-
tainer is refitted. The units return
to the previously selected mode.
In an unsupervised continuous
mode with external condensate
connection, the produced
condensate is continuously drained
via a hose connection on the
condensate container.
The units are designed for
universal and problem-free
dehumidification.
Owing to their compact size, they
are easy to transport and install.
The units operate according to the
adsorption principle and are pro-
vided with ioniser, low noise and
maintenance recirculation fans as
well as a power cord with plug.
The fully automatic control, the
condensate container with inte-
grated overflow protection and the
drain connection for direct con-
densate discharge ensure trouble-
free operation.
The units comply with the
fundamental safety and health
requirements of the pertinent EU
directives.
The units are reliable and easy to
operate.
The units are used wherever
dehumidification is necessary and
consequential damage (e.g. due to
mould formation) is to be avoided.
The units are also suitable for
drying and dehumidification of:
■ Living rooms, bedrooms,
shower or cellar rooms, lofts
■ Utility rooms, weekend homes,
caravans
■ Museums, archives, laboratories
■ Wellness areas, washrooms and
changing rooms, etc.
■ Garages, store rooms
The air flow is cooled on its way through or via the condenser to
below the dew point. The water vapour condenses and is collected
in a condensate trap and discharged.
saturated air
condenser
condensate container
humid
room air
regenerative
heating element
adsorption rotor dehumidified
room air