REMKO SLV11-88-2 - Manual (Page 15)

15
Measurement and Service Log
Service Instructions
Only have the forced-air oil burner serviced by trained
and authorised personnel in accordance with the legal
requirements. It is not permitted to service compo-
nents with safety functions. They may only be replaced
with original parts.
To ensure the optimum function of the burner, dirt and
dust must be cleaned from the entire burner after every
heating period or earlier depending on the operating con-
ditions.
Parts subject to wear and tear such as oil filters (on the
unit side) and oil nozzles must be checked and replaced
if necessary.
Each time the unit is serviced, the exhaust must be
measured in accordance with § 14 of the German Emis-
sions Law.
Model size / device type (warm air generator) /
Burner number / device number (warm air generator) /
CO
2
content on the exhaust pipe adapter
%
CO content on the exhaust pipe adapter %
Amount of soot according to Bacharach
Exhaust gas temperature °C
Heating room temperature °C
Exhaust temperature minus room temperature °C
Chimney draft on the exhaust pipe adapter mbar
Excess pressure in the furnace room mbar
Exhaust losses %
Furnace efficiency degree %
Burner cleaned
Impermeability of oil-conducting lines checked
Safety mechanisms checked
Protective mechanisms checked
Nozzle replaced
Filter checked/replaced
Comments: ...................................................................................................................................................................
......................................................................................................................................................................................
1st Date: ...................
.................................
Signature
2nd Date: .................
.................................
Signature
3rd Date: ..................
.................................
Signature
4th Date: ...................
.................................
Signature
5th Date: ...................
.................................
Signature
6th Date: ..................
.................................
Signature
7th Date: ..................
.................................
Signature
8th Date: ..................
.................................
Signature
9th Date: ...................
.................................
Signature
10th Date: .................
.................................
Signature
Maintenance steps:
à Clean any combustion residue sticking to the swivel
disc.
à Check the distance of the ignition electrodes.
Reposition if necessary or replace the ignition elec-
trode.
à Clean the filers of the pump and magnetic valve.
à Replace the oil nozzle when necessary.
à Clean the nozzle connection rod and the oil line.
à Clean any dust or dirt particles sticking to the fan
wheel if necessary.
à Check the pump pressure and adjust if necessary.