REMKO DZH 20-2 - Manual (Page 4)

4
REMKO DZH
Safety Notices Device Description
When using the appliance, always observe the respective local construc-
tion and fire protection ordinances as well as the regulations of the
employers‘ liability insurance associations.
The appliances were subjected to
extensive material, functional, and
quality tests before delivery. Never-
theless, the equipment may present
a danger if it is used by untrained
personnel, improperly, or not accor-
ding to regulation!
Please observe the following
notices:
■ Before maintenance or servicing
work, the mains plug must be
removed from the socket
■ The unit may be operated only
by personnel who have been
trained in its operation
■ The unit must be set up and
operated in such a way that
people are not endangered by
exhaust fumes and radiated
heat and no fires can break out
■ The unit may be set up and
operated in rooms only if there
is a sufficient amount of air for
the combustion
■ The unit may be operated
without an exhaust duct only in
well-ventilated rooms. People
may not constantly be in the
mounting room
Corresponding prohibition
signs must be posted at the
entryways!
■ The unit may not be operated
without supervision
■ Mount the unit only on a
level, non-flammable base
■ The unit may be set up and
operated only in an environ-
ment not at risk of fire or explo-
sion
■ The unit may not be set up in
atmospheres containing oil,
sulphur, or salt
■ A safety zone of 3 m around
the exhaust and 1 m around
the unit and non-flammable
objects must be
observed
■ The protective air suction grille
must always be free of dirt and
loose objects
■ Never insert foreign matters
into the unit
■ The unit may not be exposed to
direct water jets, such as high-
pressure cleaning unit, and so
on
■ All electrical cables of the unit
must be protected from dama-
ge (e.g. due to animals)
■ Safety equipment may neither
be bridged nor blocked!
■ Due to the design, a perma-
nent, fixed-location installation
is not intended for this type of
unit
The unit is a mobile heater and is
directly fueled with EL heating oil
or diesel fuel.
The unit works without an exhaust
connection and is solely designed
for commercial use.
The unit is equipped with a fuel
container underneath, fuel fil-
ters, maintenance-free axial fans,
high-pressure spraying furnace
with optical flame monitor, room
thermostat socket, and mains cable
with an earthing contact plug.
The unit complies with the basic
safety and health requirements of
the relevant EU stipulations and is
easy to operate.
Among other things, the devices
have the following uses:
■ Spot heating of
outdoor workplaces
■ Spot heating of
workplaces in open, non fire-
hazard production rooms and
halls
■ Temporary heating of rooms
with a sufficient fresh-air supply
■ De-icing of machines, vehicles,
and non-flammable warehouse
goods
■ Temperature control of parts at
risk of frost
The units may be set up only
in well-aerated rooms and not
in living areas or lounges.
CAUTION !!