Digi MIL-4511H User Manual
Mil-4511h, Snmp manageable hub, User’s guide
Doc. Number: 75424 Rev. A
MIL-4511H
SNMP Manageable Hub
User’s Guide
This guide includes the following information:
“Micro Modules used with the MIL-4511H:” on page 2
“Description of Hardware” on page 3
“Description of the LEDs” on page 3
“Description of Dip Switches” on page 3
“Installation Procedure” on page 4
“Installation of Micro Modules” on page 4
“Installation of Rack Mount Ears” on page 5
“Installation of the Rubber Feet” on page 5
“Installation of the Interconnect Cable” on page 6
“Assigning an IP Address” on page 7
“Verifying the IP Address is Set Properly” on page 11
STACK
PWR
MBUS
MSYS
OUT
IN
HUB 24Port 10BaseT with Modular Uplink Ports, SNMP Management Module Installed
RX
CX
MODEL MIL•4511
LINK
RECEIVE
PARTITION
Table of contents
Document Outline
- MIL-4511H
- Micro Modules used with the MIL-4511H:
- The MIL-4511H Package Contents
- Description of Hardware
- Description of the LEDs
- Description of Dip Switches
- DB-9 Serial Port
- Installation Procedure
- Installation of Micro Modules
- Installation of Rack Mount Ears
- Installation of the Rubber Feet
- Installation of the Interconnect Cable
- Port Redundancy
- Cascading Hubs
- Assigning an IP Address
- Setting the IP Address with Telnet
- Setting the IP Address with RARP
- Setting the IP Address with BOOTP
- Verifying the IP Address is Set Properly
- Legal