REMKO RKS 510 - Manual (Page 15)

15
Signature of person assembling and
putting unit into operation
Certification for
Date 01/2003
?
Initial operation ? Subsequent operation of a REMKO air-conditioning system
? The room air conditioning system above was put into operation without any objections.
? The operator has been trained and the operating instructions distributed.
? The unit could not be put into operation for the reasons indicated above.
Company:
Street:
Postal code, city:
Stamp and signature
Executing company:
Date Operator signature
Unit data Outdoor part Indoor unit
Type of unit RKS RKV
Unit number
Refrigerant length/height of line ———– m/ m
Oil elevation arcs ———– units
Additional quantities ———– g
Condensation pump ———–
Operator / Assembly location Name:
Street: Postal code, city:
Telephone: Fax:
Test of cold cycle Result
Visual check: Assembly of outdoor part and indoor unit
R
good
Q
poor
Heat-exchanger, insulation, lines
R
good
Q
poor
Electrical fuse protection type A
R
good
Q
poor
Electrical power / control line Cu (mm² / mm²) /
R
good
Q
poor
Impermeability check Vacuum mbar
R
good
Q
poor
Excess pressure mbar
R
good
Q
poor
Add. preparation: Refrigerant refill amount g
R
good
Q
poor
Shut-off valves open
R
good
Q
poor
Functional check: Condensation flow, condensation pump(s)
R
good
Q
poor
Cooling mode
R
good
Q
poor
Operational check: Compressor mode
R
good
Q
poor
Ventilator mode
R
good
Q
poor
Measurement tests: Room temperature / Air outlet temperature°C / °C /
R
good
Q
poor
Suction temperature / Overheating °C / K /
R
good
Q
poor
Comments: