REMKO MD 261 - Manual (Page 5)

The equipment is shipped in sturdy
transport packaging. Immediately
check the equipment on delivery
and make a note of any damage
or missing parts on the delivery
note. Inform the forwarding agent
and contractual partner. Warranty
claims at a later date will not be
accepted.
The MD 261-351 room air
conditioning units have a REMKO
MD...AT outdoor component as
well as an indoor unit MD...IT.
The outdoor component serves
to output the heat extracted by
the indoor unit from the room
being cooled. In heater operation,
the heat taken up by the outdoor
component can be discharged
by the indoor unit into the room
to be heated. In both operating
modes, the performance of the
compressor is adjusted precisely
to the requirement which thereby
regulates the set temperature with
minimal temperature variation.
This "inverter-technology" enables
power saving over a conventional
split-system and also reduces noise
emissions to a particularly low
level.
The outdoor component can be
installed outside or in indoor areas,
if certain requirements are met.
The indoor unit is designed for the
upper wall area in the interior. It
is operated via an infrared remote
control.
The outdoor component consists
of a refrigerant circuit with
compressor, fin liquefier, liquefier
fan, reverse flow valve and flow
regulator. The outdoor component
is controlled via the regulation of
the indoor unit.
The indoor unit consists of
a fin evaporator, evaporator
fan, regulation system and
condensation pan.
Floor consoles, wall consoles,
refrigerant pipes and condensation
pumps are available as accessories.
Unit description
Transport and
packaging
The connection between the indoor unit and the outdoor component
made with refrigerant pipes.
Schematic of refrigerant circuit in indoor unit - cooling
Vaporiser fan
Connection to suction pipe
Connection to injection pipe
Vaporiser
Schematic of exterior refrigerant circuit
M
M
Liquefier fan Reverse flow valve
Liquefier
Filter dryer Capillary tube flow regulator
Connection
valve
Injection pipe
Connection
valve
Suction pipe
Compressor
Connection
Manometer
Outdoor
component
System layout
Stop valve
Indoor unit
Liquefier fan
Outdoor area
Injection pipe
Suction pipe
Control cable
Mains cable
Condensation pipe
Indoor area
Condensation pipe
5