REMKO MKT 250 - Manual (Page 4)

REMKO MKT
7
6
4
14
1
5
2
3
Infrared
transmitter
5
1 On/off “Power“ button
2 “Mode“ button
3 “Fan Speed“ button
4 “Timer“ button
5+6 Temperature/time setting buttons
“Timer/Temp. Adjust“: 5 higher, 6 lower
7 Display
8 Red fault LED: Reservoir full (s. p. 7 Trouble Shooting)
An acoustic and an optical signal indicate that the float switch of the internal
reservoir has shut down the operation of the device. The acoustic signal dies
down after a short period of time, but the LED remains active.
9 Mode LED
Green: “Cool“
Orange: “Dehumidify“
Yellow: “Fan“
10 Orange LED for the fan speed, with high/medium/low speed “High“/“Med“/
“Low“
11 Green LED for the time delay, “Timer“
12 Green “Room Temp“ LED
(If this LED lights up the current room temperature is shown in the display (7))
13 Green “Set Temp“ LED
14 “°C/°F“ toggle button (only on the remote control)
Operation
The device is operated comfortably using
the control panel on the device or the in-
frared remote control. Keys with the same
symbols have the same function.
“Mode“ selection (2)
■ “Cool“
The device is used to cool the room. It filters
and dehumidifies the air and thus creates a
pleasant room climate.
■ “Dehumidify“
In the “Dehumidify“ mode, humidity is
removed from the air.
■ “Fan“
The device circulates the air, filters it, and
creates an even air flow.
Fig. 11
Control panel Fig. 12
Infrared remote control
■ Point the infrared transmitter of the
remote control at the infrared receiver
on the control panel.
■ In order for the signal to be received
without interference, there should be
no objects between the remote control
and the device (reach of approx. 5 m).
■ The proper reception of the signal is
indicated acoustically.
1
Infrared
receiver
2 3 4 5 6
8 9 10 11 12 13 7