REMKO MKT 250 - Manual (Page 2)

REMKO MKT
Control panel
Transport
rollers
Air directing
plate fins
Infrared receiver
Exhaust air
outlet
Air inlet
(exhaust air)
Condensate drain spout
with plug
Air outlet
hose
Air inlet
(circulation air)
with air filter
Recessed grip
3
Before delivery, this device was sub-
jected to numerous material, function,
and quality tests. Nevertheless, the
device may present a danger if used by
untrained personnel, improperly, or not
according to regulation!
Observe the following notices:
■ The device is not suited for out-
door operation.
■ The device may not be set up and
operated in rooms at risk of explo-
sion and in atmospheres containing
oil, sulphur, or salt.
■ Make sure it is at a sufficient
security distance to inflammable
objects.
■ Do not place any objects on the
device.
■ Observe the minimum clearances
(Fig. 2).
■ Do not insert any objects into air
inlets and outlets.
■ Erect the device on an even, stable
surface. Never place it on its side
(Fig. 3).
■ Operate the device only when it is
upright.
■ Do not expose the device to direct
water spray.
■ Operate the device only within its
permissible operating limits (16 to
35°C).
■ Do not pull on or bend the mains
supply line.
■ Protect all electrical lines of the
device from damage, even from
animals.
■ Select the extension lines of the
mains supply line depending on
the connected load of the device,
the line length, and the intended
use.
■ Do not lay lines under carpeting.
■ Never operate the device with-
out an air filter.
■ Never direct the air flow at
people.
■ Never open the device housing
as there is a danger of an electri-
cal shock.
■ Work on the cooling system and
the electrical equipment may be
carried out only by an
authorised specialist.
Transporting the device
■ Before transport, switch off the
device and pull the mains plug.
■ Transport the device only in an
upright position.
■ We recommended that any
condensate be drained using the
condensate drain spout on the
back side of the device before
transport.
■ After every transport of the
device, wait at least 5 minutes
before recommissioning it
(Fig. 4).
Safety Notices
Operation other than as de-
scribed in these instructions is
prohibited. Nonobservance leads
to the extinguishment of any
liability and warranty claims.
Fig. 2
Minimum clearances
Side
500 mm
Front 500 mm
Rear
400 mm
Top 100 mm
Scope of Supply
1 MKT 250 air conditioner
1 Infrared remote control
2 Batteries (type AAA/1.5 V)
1 Air outlet hose with connection
pipe adapter and win
dow jet
Fig. 1 MKT 250
Caution
TIP
CAUTION
DANGER