Denon AVR-2802/982 - Manual (Page 55)

ENGLIS
55
Recalling preset stations
• To call out out preset stations from the remote control unit.
1 Watching the display, press the
SHIFT button to select the preset
memory block.
SHIFT
CHANNEL
(Remote control unit)
2 Watching the display, press the
CHANNEL + (UP) or – (DOWN)
button to select the desired preset
channel.
(Remote control unit)
13 LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s
power switch is off and with the power cord disconnected.
14 INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1 Switch off the unit and remove the AC cord from the wall
outlet.
2 Hold the following A button and B button, and plug the AC
cord into the outlet.
3 Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
2
VOLUME LEVEL
AUTO
LOCK
STAND BY DIGITAL PCM
SIGNAL
DIGITAL
INPUT
REMOTE
SENSOR
B
• Calling out preset stations from the main unit‘s panel.
1 Press the TUNING PRESET button.
TUNING
PRESET
FUNCTION
2 Turn the FUNCTION knob and
select the desired station.
DVD
START LEARNED/TX
SPEAKER
TUNING
BAND TITLE MENU/GUIDE
MODE
MEMORY
USE/LEARN T.TONE MULTI SET UP
RETURN
STATUS
DISPLAY
ON SCREEN
DOLBY / DTS SURROUND DIRECT
DSP SIMULATION 5CH / 6CH STEREO STEREO
INPUT MODE ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
SYSTEM CALL POWER
VDP TUNER SHIFT
TV/DBS PHONO
VCR-1 CD CDR / TAPE CHANNEL
VCR-2/V.AUX TV/VCR
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD MULTI
CDR/MD TAPE
SYSTEM SETUP SURROUND PARAMETER
CH SELECT
SELECT
RC-903
1 2 3
4
SET
A / B
CALL OFF
ENTER
ON / SOURCE
5 6
7 8 9
+10 0
1
2
(Main unit)
2 1
VOLUME LEVEL
AUTO
LOCK
STAND BY DIGITAL PCM
SIGNAL
DIGITAL
INPUT
REMOTE
SENSOR
B
(Main unit)