RADO Ceramica_Multifunction - Manual (Page 5)

display alternates between the
hours display and the minutes, sec-
onds and hundredths of a second
display.
While the stopwatch is running,
other functions can be selected
and used. To stop and read the
measured time and to set to zero,
reselect Function 6 (CHR).
7. AL: Alarm
Select Function 7 (Alarm).
To set alarm time, pull out the
crown and set the hours by turning
quickly, the minutes by turning
slowly. Push the crown back in.
AL = acoustic signal in active
mode.
OF = acoustic signal deactivated.
To activate the acoustic signal, se-
lect Function 7 (AL) and press the
crown briefly. To deactivate it,
press the crown briefly again.
Note:
The alarm time can be set in the
2
i12 hours (A.M.-P.M.) or the
24-hour mode. This should be
taken into account when setting
the alarm time (see Function 5).
8. Only analogue hours and
minutes display
Select Function 8: the digital dis-
play disappears.
For adjustment of the hands see
Function 1.
IMPORTANT
Crown
After the crown has been pulled
out for any adjustment to be
made, do not forget to push it back
in to its normal position right
against the side of the case. Other-
wise there is a danger of damp,
water or dust getting in.