DeLonghi ESAM6600 - Manual (Page 13)

C o l l e c t i o n 12
7 CHANGING THE QUANTITY OF COFFEE IN THE CUP
The appliance is factory preset to automatically deliver the following quantities of coffee:
-
one short coffee (when the button is pressed);
- one long coffee (when the button is pressed);
- two short coffees (when the button is pressed);
- two long coffees (when the button is pressed);
To change these quantities, proceed as follows:
-
Press the button (or or or ) corresponding to the quantity you want to change
for at least 8 seconds, then release until the message "PROGRAM QUANTITY" is displayed and coffee is
delivered.
- When the coffee in the cup reaches the required level, press the same button again to memorize the new
amount. The appliance emits a double beep to confirm.
The appliance is now re-programmed with the new settings and displays: READY.
8 REGULATING THE COFFEE MILL
The coffee grinder is preset in the factory to prepare coffee correctly and should not require regulating initial-
ly.
However, after making the first coffees, if you find that coffee delivery is either too fast or too slow (in drips),
the grinding coarseness regulator can be adjusted (fig. 11).
Turning it 1 click (1 line) toward the number 7 speeds up coffee delivery (without drips).
Turning it 1 click toward the number 1 slows down delivery, giving a creamier appearance to the coffee.
These adjustments will only be evident after at least 2 cups of coffee have been brewed.
The grinding coarseness regulator must only be turned when the coffee mill is running.
Turn one click toward the number 1 to obtain finer ground coffee,
slower delivery and a creamier appearance.
Turn one click toward the number 7 for coarser ground coffee and
faster delivery (not a drop at a time).
9 PREPARING ESPRESSO COFFEE WITH GROUND COFFEE (INSTEAD OF BEANS)
Coffee has been used to factory test the appliance and it is therefore completely normal for there to be
traces of coffee in the mill. This appliance is, however , guaranteed to be new.
• Select the ground coffee function by pressing the /OK button (fig. 1) repeatedly until
READY - PRE-GROUND COFFEE
flashes on the display. This disables the coffee mill function.
• Lift the central lid, place one level measure of ground coffee in the funnel (see fig. 15) and proceed as
described in section 6. NOTE: You can make just one coffee at a time by pressing the or button.
• Once the coffee has been delivered, to go back to making coffee using beans, deactivate the ground cof-
fee function by pressing the /OK button, and the coffee mill is enabled for operation again.
NOTE 1: Never add the ground coffee when the appliance is off to avoid it being dispersed inside the appli-
ance.
NOTE 2: Never add more than one level measured scoop; otherwise either the appli-
ance will not make the coffee and the ground coffee will be lost inside the appliance,
dirtying it, or the coffee will run off in drips and the message “LESS COFFEE” will be dis-
played.
NOTE 3: When measuring the quantity of coffee to be added, use the measuring scoop supplied only.