DeLonghi ESAM6600 - Manual (Page 12)

11 C o l l e c t i o n
NOTE 5: As soon as delivery is complete, to increase the quantity of coffee, simply press and hold the coffee
button previously selected (fig. 10), until the desired quantity is reached (this operation must be performed
within 3 seconds from when coffee delivery from the spouts ceases).
NOTE 6: When the appliance displays:
FILL TANK
(and emits a double BEEP), the water tank must be refilled or the appliance will not make coffee.(It is normal for
there to be a little water left in the tank when the message is displayed.)
NOTE 7: The appliance counts the number of coffees made. Every 14 single coffees (or 7 doubles) the appli-
ance displays:
EMPTY GROUNDS CONTAINER
(and emits a double BEEP), indicating that the grounds container is full and must be emptied and cleaned. Until
the grounds container has been cleaned, the appliance continues to display the message and cannot make
coffee.
To clean, open the service door at the front by pulling the handle (fig. 13), remove the drip tray (fig. 14), empty
and clean.
Empty the grounds container and clean thoroughly, making sure all residue deposited on the bottom is
removed.
IMPORTANT: When removing the drip tray, the grounds container MUST be emptied, even if it is not completely full.
If this is not done, when making your next coffee, the grounds in the container may exceed the maximum level and
block the appliance.
NOTE 8: While the appliance is delivering coffee, never remove the water tank. If it is removed, it will not be
possible to make the coffee and the appliance will display:
GROUND TOO FINE ADJUST MILL AND
INSERT WATER SPOUT AND PRESS OK
To turn the appliance on again, you must insert the hot water spout (fig. 4), press the OK button and run off
water from the spout for a few seconds.
When using the appliance for the first time, 4-5 cups of coffee need to be made before the appliance
starts to give satisfying results.
If the appliance malfunctions, do not contact the service center right away.
The problem can almost always be resolved by following the instructions indicated in sections 19 and 20.
If this is not the case, or for further explanations, contact customer service by calling the number listed in the
warranty or visit www.delonghi.com for a list of service centers near you. (U.S. and Canada only)