Mounting the scope, Setting the safety, Mounting the quiver – PSE Archery Crossbow User Manual

Page 4: Crossbow owner’s guide

CROSSBOW OWNER’S GUIDE

Fig. 2

Fig. 1

(Reaper and Copperhead only)

Mounting the Scope

Loosen screws on the scope rings and mount the scope to the

7/8” dovetail scope rail. (Fig.1)

Set the scope on the scope rail in the desired position and
secure the screws. (Fig 2)

Setting the Safety

The safety lever (located on the side of the trigger assembly)

is provided for your safety. Familiarize yourself with the correct
position prior to use! The illustration below shows the correct

position for safe and fire positions.

Note: The quiver can be
installed in either direction.

Fig. 3

Fig. 4

Fig. 5

Mounting the Quiver

Parts to install quiver:

A. Quiver
B. Quiver mount bracket
C. Dovetail bracket
D. Backing plate

(Reaper and Copperhead only)

E. Round head screws

F. Flathead screws

G. Allen key

(Reaper and Copperhead only) Place backing plate (D) over two holes on

underside of prod (Fig. 1) and secure with the two flat head screws (F) with the

Allen key provided (G)

(All models) Secure the dovetail bracket bracket (C) to the quiver (A) using the

round head screws (E) with a Phillips screwdriver. (Fig. 2)
Mount the quiver mount bracket (B) to the underside of the prod assembly using

flathead screws (F). Slide the the quiver into the mounting bracket (Fig. 4) and

secure using the locking lever (Fig. 5)

Fig. 1

Fig. 2