PSE Archery Crossbow - Manual (Page 3)

CROSSBOW OWNER’S GUIDE CROSSBOW OWNER’S GUIDE
® ®
4 5
Compound Crossbow Assembly
Before shooting your crossbow, some basic assembly is required.
Mount prod to stock assembly. Clip the cable slide (A)
on top of the cables with one cable in each slot.(Fig.1)
Place slide in the center of the prod.(B) Slide cables and
slide into cable slot of stock assembly with the string riding
on top of the rail. Insert the prod into stock assembly (D) as
shown in (Fig. 2) and secure with the prod attachment screw
(E) (Fig. 3), Tighten screw with the Allen key provided (F).
Place the stirup (C) into the front mounting holes of the prod
assembly (Fig. 4) and tighten the set screws (G)
Stock assembly
Fore-end
B
G
C
D
E
Prod
Stirrup
(set screws pre-installed in prod)
Cable Slides
Left) for steel cable system
Right) for synthetic cable system
A
Prod Assembly Mounting Bolt
Left) for Reaper and Copperhead
Right) for Foxfire and Crossfire
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Set Screws
F