PSE Archery X Factor - Manual (Page 6)

-6-
PSE INTEGRATED LIMP POCKET
ALIGNMENT SYSTEM
Stainless Steel Limb Bolt
Factory set at minimum weight (4 turns from bottom). Draw weight can be
increased to approximately 10% over marked limb weight at 28”. Loosen the
setscrew on the backside of the limb bolt receiver. Turn the limb bolt clockwise
to desired position and then lock by retightening the setscrew.
Limb Bolt Receiver
Factory set for bow alignment.
Variances in limbs or stabilizers
may require fine-tuning.
To Align Limbs
Place a strip of masking tape on the limb where it
exits the pocket. Mark the center of the limb on the
tape. Loosen the hollow lock screws on each side of
the pocket. Insert Allen wrench through the hollow
lock screws into the adjustment screws. Move the
limb bolt receiver by loosening the screw on one side
and tightening the opposite screw until the desired
alignment is achieved and screws are tight.
Properly Aligned Bow
When finished, the stabilizer and marks on
the limbs should all be aligned. (see next
page for details)