PSE Archery Bow 2009 - Manual (Page 11)

11
Compress ONLY far enough to loosen
the string and cables. Over compressing
could break the limbs and cause
personal injury. Any damages incurred
from over-compressing will not be
covered under warranty.
PULL-TYPE PRESS:
This type of press pulls the riser of the bow in
a vertical direction between rollers that
compress the limbs.
When using this type press it is very
important to position the rollers and pressure points correctly.
Back the limb bolts out 4 turns from the bottom setting
and position the pressure points on the riser as close to
the limbs as possible WITHOUT making contact with the
limbs as shown in the photo. The pressure points must
not contact the limbs at any time during servicing.
(Continued on page 12)