PSE Archery Compound Bow 2015 - Manual (Page 30)

COMPOUND BOW
USER’S GUIDE
PAGE
31
PSE VISION
™
CAM INFORMATION
BOWS: PSE VISION ™ , PSE FEVER ™ AND
PSE MINI BURNER ™ XT
ADJUSTING THE VISION ™ CAM:
DRAW LENGTH:
STRING POST ADJUSTMENTS
PSE Vision cams have a string post adjustment for draw length as well as inner cam
adjustments and “Flexible Cam” adjustments. To make a string post adjustment, compress
the bow in a suitable bow press and relieve tension from the string and cables. See the draw
length adjustment chart for your bow for details.
Select the draw length and the “PERFORMANCE” or “GROW WITH YOU” cable position
based on the desired draw characteristics and peak weight range. If your desired draw
length lies in the short post category, an approved bow press will be required to make this
adjustment.Once the string is positioned onto the string posts of your choice, adjust the
inner-cam to the desired location.
The inner-cam has holes marked “A” through “J” for adjusting draw length as well as a set of
threaded holes marked “S” and “L”. The “L” holes are used for longer draw lengths and the
“S” holes are used for shorter draw lengths. See the following tables for the setting required
to achieve different draw lengths and weight for bows using this cam.
To make the necessary adjustment, remove the screw holding the inner-cam in place and
rotate the inner-cam so the letter setting desired lines up with the threaded “L” or “S” hole
in the cam. Replace and tighten the screw. IT IS IMPORTANT THAT BOTH TOP AND
BOTTOM CAMS BE ADJUSTED THE SAME. These adjustments can be made either with or
without a bow press.
PAGE
31