PSE Archery Fang Crossbow 2015 - Manual (Page 6)

CROSSBOW OWNER’S GUIDE
®
6
MOUNTING THE QUIVER
Parts to install quiver:
A. Quiver
B. Quiver mount bracket
1. Screw the quick release mounting bracket on to the PICA-CLIP ® mounting
system. Fig. 7a
2. Attach the PICA-CLIP® mount onto your desired position on the lower
picatinny of the front rail. Fig. 7a
3. Tighten the PICA-CLIP® mounting screw from the side and make sure it’s firmly
attached. Fig. 7a
4. Slide the quiver into the groove on the quick release mounting
bracket. Make sure the locking lever is in the open position. Fig. 7b
5. Lock the quiver by turning the locking handle, you can unlock and remove the
quiver by opening the locking handle.
A
B
SCOPE INSTALLATION & SETUP
1. Slide 4x32 scope (Fig. 8a) over rail mount. Tighten with included hex wrench.
Fig. 8b
2. Begin adjusting your scope by sighting your crossbow at the closest yardage
from which you plan to hunt. Ex. 10 yards = top line of crosshairs.
3. Once you’ve established your closest range, progressively move back in yardage
to determine the yardage points for the remaining lines in your crosshairs.
4. Because all of the sight lines move together, you will make adjustments based
on your closest sight point by using the Windage (side) and Elevation (top)
knobs.
NOTE: SCOPE RETICLE & KNOB MAY VARY FROM MODEL TO MODEL.
ALSO BE CAREFUL NOT TO MOVE THE SCOPE BASE WHEN MAKING YOUR
ADJUSTMENTS