Directed Electronics K10 - Manual (Page 9)

10
3. Transmit. The transmitter is used to select the desired setting. As shipped, the unit
is configured to the LED ON settings. These are the default settings. Pressing the lock
button will set it to the LED ON setting. The LED will light solid (stop flashing) to indi-
cate the setting. The horn will honk once (if connected). Pressing the unlock button will
change the setting to the LED OFF setting. The LED will go out indicating the change
and the horn will honk twice (if connected).
4. Release. The Override switch can now be released.
For example, to program the arming mode from active to passive, within 10 seconds of turning the
ignition off, and press and release the Override switch once. Then press it again and hold it. The LED
will flash in groups of one and the horn will honk once (if connected). While holding the Override
switch, press the unlock button. The LED will stop flashing and go out. The horn will honk twice if con-
nected. Passive arming is now programmed. If that was not the desired setting, without releasing the
Override switch, press the lock button. The LED will light solid and the horn will honk once if connect-
ed. Active arming is now programmed. Release the Override switch after the selection has been made.
You can advance from feature to feature by pressing and releasing the Override switch the number of
times necessary to get from the feature you just programmed to the feature you wish to access. For
example, if you just programmed Feature 2 and you next want to program Feature 3 to off, release the
Override switch. Press and release it once to advance from Feature 2 to Feature 3. Then press it once
more and hold it. The LED will flash in groups of three and the horn will honk three times (if connect-
ed) to confirm that you have accessed Feature 3.
The learn routine will be exited if:
➤ The ignition is turned on.
➤ The Override switch is pressed too many times.
➤ More than 15 seconds elapses between programming steps.
One long horn honk (if connected) indicates that the learn routine has been exited.