Directed Electronics K10 - Manual (Page 7)

8
door lock harness (H4), wire connection guide
___
___
___
peripheral plug-in harnesses
LED, 2-pin WHITE plug
The LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make sure the LED wires are
not shorted to ground as the LED will be damaged. Multiple LED’s can be used, but they must be wired
in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance prior to drilling
the mounting hole.
N NO OTTEE:: Never use a BLUE LED in combination with a RED LED.
override switch, 2-pin BLUE plug
The override switch should be accessible from the driver’s seat. It plugs into the BLUE port on the side
of the unit. Consider how the button will be used before choosing a mounting location. Check for rear
clearance before drilling a 9/32-inch hole and mounting the button.
DIA-41
IIm mp poorrtta anntt!! The door lock outputs are low current and should not be attached directly to any
high current device; they are only to be used to activate relays
Blue (-) Unlock, (+) Lock Output
Empty Unless Using Resistor Interface
Green (-) Lock, (+) Unlock Output
H2/A
H2/B
H2/C