Posiflex TM-6100 - Manual (Page 6)

6
6. Screw from both sides through supporting brackets (A and B) and from top
onto the rear connect opening of TP7000 series as pointed by arrows in the
pictures.
7. Connect the 10 pin RJ45 plug end of the touch
control cable to the jack in the rear of the panel
till it clicks. Connect and screw fix the VGA
cable as well.
8. Route both cables to enter TP7000 series through the
opening as in the picture to the right. Connect them to
the appropriate COM port and VGA port of TP7000
series per instructions for TP7000 series. Please
remember to ask a qualified technician to enable the
power supply in the VGA port according to Posiflex
technical instruction but please do not enable power
in the COM port.
9. Join TM6101 (E) onto
brackets on TP7000 (H)
to become the picture
to the right.
10. Fix the final 4 screws
as pointed by arrows in
the picture to the right.
Touch
Control
VGA
A B
C
H H
H
A
B
H
E
H
E
H
E