Posiflex CR-6000 Series - Manual (Page 5)

Part 5
CR4001/ 4101/ 4211/ 4002/ 4102/ 4212/ 4003/ 4103/ 4213 Rear panel
illustration.
S1 Set security code. (Default Setting: BIT 1,2,3 OFF and BIT
4,5,6,7,8 ON. Security code is 07H)
BIT 1 2 3 4 5 6 7 8
Number to be added to the
security code if OFF.
1 2 4 8 16 32 64 128
S2 BIT1 ON and BIT2 OFF to receive security code via Pin2 of P4
(DB9F).
BIT1 OFF and BIT2 ON* to receive security code via Pin3 of P4
(DB9F).
BIT3 OFF and BIT4 ON for dedicated RS-232C.
BIT3 ON and BIT4 OFF* for non-dedicated RS-232C.
(* denotes factory default setting)
CR4004 / 4104 / 4214 / 6214
1).
Open the PC case. Put the
metal bracket with power
connector into one of the
I/O windows.
2).
Connect the cable to the
HDD type power
connector of PC power
supply. See illustration
below. Then close the PC
case.
AC 12V I/P
SERIAL O/P (DB9M)
SERIAL I/P (DB9F)
PARALLEL O/P (DB25F)
PARALLEL I/P (DB25M)
1 8 4 1
GROUND
S2 S1
Switch is ON when pushed up
616P PHONE JACK
POWER CORD