Posiflex PD-2800UE - Manual (Page 4)

Page 3
Note: Please align the compress lock and the grooves in order to fix the
height of customer display.
Picture B is going to show how to screw PD-2800/320 in a flat surface.
In the base stand of PD-2800/320, there are two screws holes for user to fix the
customer display. Please choose a flat surface to fix the customer display in
order to keep the PD-2800/320 stable. (The screws are come with PD-
2800/320 and in the carton)
Picture C, the display head of PD-2800/320 can move as horizontal direction
to right or left, as well as front-rear adjustable degree from 1
5° or 23°
Picture D, there are two plates in the bottom of customer display which can
use for Velcro and provides more stable without screws fixed. (The Velcros
are come with PD-2800/320 and in the carton)
INSTALLATION FOR REAR BASE MOUNT MODEL
For this type mechanical design of rear base
mount pole display, it needs to assemble with any
a host system. For base stand of host system, it
only suit for Posiflex Gen. 1
st
base and which will
show in the following steps. Please follow the
instruction to assemble this customer pole display.
Step 1: Please pass the connecting cable through the hole
which in the base metal plate.
Step 2: Hold the display with pole and aim to the base
metal plate as well as let these four screw tubes join these
holes which in the end of pole. Please notice that the
customer display face to the short side of metal plate.
Step 3: Turn the pole display and base stand upside-down before combination.
Pass the cable through base stand and connect to the host system.
Step 4: Aim the hole which on the metal plate to the
rubber foot on the Gen. 1
st
base stand’s bottom as show
in the right picture. Hold the system with customer
display and turn them upside down to the regular
position.