Dimplex DS7420 - Manual (Page 3)

3
Remote Control
The stove is supplied with an integrated On/Off remote
control.
! NOTE: Ensure that the stove’s Three Position Switch is
set to the remote Control setting ( “ II” position).
To operate, push the ON button to turn stove on, push the
OFF button to turn the stove off.
Remote Initialization
Follow these steps for remote control initialization and if
required, re-initialization:
Disconnect power to stove. 1.
Set the Three Position On/Off Switch to the Remote 2.
position (Figure 1A).
Wait a minimum of five (5) seconds and then re-acquire
3.
power to stove.
Within 10 seconds of re-acquiring power, press the ON
4.
button located on the remote control transmitter.
! NOTE: You will have only 10 seconds to perform this
last step. Failure to do so will result in these steps
needing to be followed again.
Battery Installation
To install or replace the battery:
Slide battery cover open on the hand held transmitter 1.
(Figure 2).
Correctly install one (1) 12 volt (A23) battery in the
2.
battery holder.
Close the battery cover.
3.
Battery must be recycled or disposed ofproperly.
Check with your Local Authority or Retailer for
recycling advice in your area.
OPERATION
To access the controls, go to the back of the stove (Figure
1).
Figure 1
A. Three Position On/Off Switch
The switch has two On positions marked with “
I” and “II”.
The “ I” position is for manual operation. In this position the
built-in remote control is bypassed.
The “
II” position is for operating the unit with the provided
remote control. When in “ II” position the unit is operated
with the ON and OFF buttons of the remote control.
When the switch is in the center position “
O” the unit is off.
B. Light On/Off Switch
The Light On/Off Switch supplies power to the upper light of
the log bed display area.
C. Heater On/Off Switch
The Heater On/Off Switch supplies power to the heater.
D. Heater Thermostat Control
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to
turn on the heater. When the room reaches the desired
temperature, turn the thermostat knob counter clockwise
until you hear a click. Leave in this position to maintain the
room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will
turn on.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the heater off and it will not come back on without being
reset. It can be reset by switching the Three Position Switch
to Off “ O” and waiting five (5) minutes before switching the
unit back on.
CAUTION: If you need to continuously reset the heater,
unplug the unit and call Customer Service at
1-888-346-7539.
Figure 2
Off Button
On
Button
Battery
Cover
Plastic
Strip
A B C
D