Dimplex ADG20 - Manual

635
516
115
245
Dimensions
(millimetres)
Installation and Operating Instructions
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the
voltage marked on the heater must correspond to the supply
voltage.
Before switching on, please read the safety warnings and
operating instructions.
For your convenience, the heater is fitted with a rewireable
plug incorporating a 13 amp fuse. In the event of replacing
the fuse in the plug supplied, a 13 amp fuse approved by
ASTA to BS1362 must be used.
Electrical
Dimplex Adagio Fire
Model : ADG20 08/19310/0 Issue 0
Fig. 1
Important Safety Advice:
When using electrical appliances, Basic precautions
should always be followed to reduce the risk of fire,
electrical shock, and injury to persons, including the
following:
••••• If the appliance is damaged, check with the
supplier before installation and operation.
••••• Do not use outdoors.
•••••
Do not use in the immediate surroundings of a
bath, shower or swimming pool.
••••• Do not locate the heater immediately below a fixed
socket outlet or connection box.
••••• Do not cover the heater. Do not place material or
garments on the heater, or obstruct the air
circulation around the heater, for instance by
curtains or furniture, as this could cause
overheating and a fire risk.
••••• This appliance is not intended for use by children
or other persons without assistance or
supervision if their physical, sensory or mental
capabilities prevent them from using it safely.
Children should be supervised to ensure that they
do not play with the appliance.
••••• Do not use this heater in series with a thermal
control, a program controller, a timer or any other
device that switches on the heat automatically,
since a fire risk exists when the heater is
accidentally covered or displaced.
••••• Ensure that furniture, curtains or other
combustible material are positioned no closer
than 1 metre from the heater.
••••• In the event of a fault unplug the heater.
••••• Unplug the heater when not required for long
periods.
••••• Although this heater complies with safety
standards, we do not recommend its use on deep
pile carpets or on long hair type of rugs.
••••• The appliance must be positioned so that the plug
is accessible.
••••• If the supply cord is damaged it must be replaced
by the manufacturer or service agent or a
similarly qualified person in order to avoid a
hazard.
General
Unpack the heater carefully and retain the packaging for
possible future use, in the event of moving or returning the
fire to your supplier. Loose coals and pebbles are packed
separately within the carton. When the heater is assembled
the coals or pebbles are placed on top of the fuel bed. ‘The
coals may be removed and pebbles added in their place up
to a maximum weight of 6KG.
The heater is designed for use inset into a 407mm (16") or
457mm (18") wide by 559mm (22") high fireplace opening
see also section “Installation in a fire place opening”.
A 2kw fan heater discreetly positioned in the canopy of the
fire provides heating in cold weather. Switching allows half
or full heat.
Before connecting the heater check that the supply voltage
is the same as that stated on the heater.
Please note: Used in an environment where background
noise is very low, it may be possible to hear a sound which
is related to the operation of the flame effect. This is normal
and should not be a cause for concern.
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE