Permasteel PG-50601SRL(N) - Manual (Page 30)

27
Usage:
1) Read instructions before lighting.
2) Open the lid during lighting.
3) Simply place a lighted match between the coils on the end of the lighting
rod and hold next to the burner to ignite.
4) Push and turn the knob to “HI ” position, make sure the burner lights
and stays lighted.
5) Repeat 3.4 to light other burners.
6) Keep a spray bottle of soapy water near the gas supply valve and check
the connections before each use. Do not light the grill if odor of gas is
present, call out service center.
ƒ FLAME CHARACTERISTICS:
1) Check for proper burner flame characteristics. Each burner is adjusted prior to
shipment; however, variations in the local gas supply may take subtle necessary
adjustments.
2) Burner flames should be blue and stable with small yellow tips, no excessive
noise, or lifting. If any of these conditions exist call our customer service line. If
the flame is yellow, it indicates insufficient air. If the flame is noisy and tends to
lift away from the burner, it indicates too much air.
3) Small yellow tips are ok.
ƒ TO LIGHT THE REAR BURNER OF THE GRILL:
1) Read instructions before lighting.
2) Turn all knobs to “ OFF ” then open the tank valve. Always keep your face and
body as far from the grill as possible when lighting.
3) Open lid during lighting.
4) Push down the safety valve switch button and hold on with right hand, allowing
the gas to reach the burner.
5) Push and turn rear burner knob slowly to “ HI ” position with left hand 2 seconds
later than push down the button. The built-in igniter will click and spark
simultaneously to light the burner once burner lights. Keep pressing safety valve
button for 15 seconds to allow the safety valve to open. Turn the control knob to
“OFF ”and release the button IMMEDIATELY if the burner does not light within
5 seconds. Wait 5 minutes for gas to dispel, then repeat the lighting procedure.
6) Follow match lighting instruction if burner can’t be lit after repeating 3-4 times.
GRILL LIGHTING INSTRUCTION