Desa CGMFP - Manual (Page 22)

www.desatech.com 119315-01A
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Slide the remote selector switch to
the REMOTE position (see Figure 33).
Note: The burner may light if hand-held re-
mote was on when the remote selector switch
was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
MPORTANT:
Do not leave the selector switch in
the REMOTE or ON position when the pilot is
not lit. This will drain the battery.
opERaTiNG FiREplaCE
Continued
Figure 34 - On/Off Hand-Held Remote
Control Unit
Figure 33 - Setting the Selector Switch
and Control Knob for Hand-Held Remote
Operation
Control
Knob
Selector Switch in
REMOTE Position
(Optional Hand-Held
Remote Control)
Electronic
Ignitor
Control
Button
Indicator
Light
ON/OFF SERIES (MODEL HRC100
AND HRC101)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 34).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together on hand-
held remote control until the light stops flashing.
The hand-held remote is now unlocked.
THERMOSTAT SERIES (MODEL
HRC200 AND HRC201)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 35). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace
Note: Do not leave the hand-held remote in the
AUTO mode close to the fireplace. The radiant
heat from the fireplace will turn off the fireplace.
Ideally, place the hand-held remote in the center
of the room facing towards the fireplace.
Note:
Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Figure 35 - Thermostat Hand-Held
Remote Control Unit
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode °C/°F
Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases
or Decreases
Room
Temperature
in AUTO Mode
Digital
Display
Shows
Temperature
and Settings