Pacific Cycles IF MODE maintenance - Manual (Page 2)

Tools required
Below shows the tools required for IF Mode adjustment, some are custom made for IF
Mode only.
1. Wheel remove adapter: use with hammer for removing wheels.
2. SpeedDrive remove adapter: use with no.7 to disassemble the SpeedDrive system at
bottom bracket.
3. 14: use with no.7 to disassemble the crank set.
4. 20: use with no.7 to disassemble wheels.
5. Crank remove adapter: use with crank remover.
6. I-type screwdriver: adjust the screw on the folding handlebar.
7. Quick wrench: use with no.3 and no.4.
8. Crank remover.
9. Hex wrench set: (size: 2.5、3、4、5、6、8、10).
10. Open/closed wrench 12: adjust linkage system.
11. Open/closed wrench 14: adjust linkage system.
12. Open wrench 13: adjust linkage system.
13. Open wrench 14: adjust linkage system.
14. Dryer: heat and soften the loctite applied on screws before loosening.
15. Hammer: use with wheel remove adapter.
Note: Three types of Loctite: red/blue/green for different adhesive strength, color
is labeled in the first page. To release the red loctite needs heat dryer to soften
first.