ONICON D-100 LonWorks User Manual
Page 6
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
D-100-LON Network Interface Installation Guide 05/14 - 0658-4 / 18342
Page 6
1.4 NETWORK SIGNAL CONNECTIONS
1.4.1 Lon Talk
Lon Talk, 2-wire serial output connections are connected to terminal T1 as shown. Do not
exceed 4.4 in-lb (0.5 Nm) of torque when tightening.
CAUTION
Only qualified service personnel should make connections between the D-100 Flow Display
and the user’s external equipment. ONICON assumes no responsibility for damage caused to
the external equipment as a result of an improper installation.
!
CAUTION
Incoming and outgoing cable shield wires should be connected together, but must not be
connected to the display.
!
T1