ONICON F-5200 Insertion - Manual (Page 3)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-5200 Insertion Thermal Mass Flow Meter Manual 05/14 - 0756-8 / 19475
Page 3
TABLE OF CONTENTS
1.0 INTRODUCTION ..................................................................................................5
1.1 PURPOSE OF THIS GUIDE .......................................................................5
1.2 TYPICAL INSERTION THERMAL MASS FLOW METER .......................5
1.3 STANDARD FEATURES AND SPECIFICATIONS ....................................6
1.4 ADDITIONAL REQUIRED HARDWARE ...................................................7
1.5 ADDITIONAL HARDWARE THAT MAY BE REQUIRED .........................8
1.5.1 Flow Conditioners .......................................................................8
1.6 WORKING ENVIRONMENT .....................................................................9
1.7 WARRANTY & SERIAL NUMBER ............................................................9
2.0 UNPACKING ....................................................................................................10
2.1 CHECKING TO SEE THAT YOU RECEIVED EVERYTHING ..................10
3.0 INSTALLATION, REMOVAL AND ADJUSTMENT ..........................................10
3.1 INSTALLATION SITE SELECTION ........................................................11
3.2 MECHANICAL INSTALLATION .............................................................13
3.2.1 Installation Kits ..........................................................................13
3.2.2 Directions For Standard Installation (new construction) ........14
3.2.3 Directions For Hot Tap Installation (pressurized system) ........14
3.3 INSTALLING THE FLOW METER ......................................................... 15
3.3.1 Determining the Insertion Depth, Inserting the Meter and
Tightening the Compression Fitting .........................................15
3.4 REMOVING THE FLOW METER ............................................................18
3.5 ELECTRICAL INSTALLATION ...............................................................19
3.5.1 Signal and Power Wiring Connections .....................................19
3.5.2 Analog Output ...........................................................................20
3.5.3 Pulse Output ..............................................................................20
4.0 START-UP & COMMISSIONING FOR ONICON INSERTION THERMAL MASS
FLOW METERS ..................................................................................................21
4.1 HELPFUL HINTS FOR START-UP & COMMISSIONING ......................21
4.2 START-UP & COMMISSIONING .............................................................22
4.3 START-UP & COMMISSIONING WORKSHEET .....................................23
5.0 TROUBLESHOOTING GUIDE ............................................................................24
APPENDIX
A-2 USE OF THE INSERTION DEPTH GAGE
A-3 CONDITIONS OF SALE