Olson Technology CAN - Manual (Page 22)

025-000570 Rev. X7 www.olsontech.com 22
J8 Status Outputs
Pin 1 Optical Output Level. 1V/mW
Pin 2 Optical Fault. Pulled to ground when a fault occurs.
Pin 3 Ground
Pin 4 RF Fault. Pulled to ground when a fault occurs.
Pin 5 RF Level. Analog test point.
D1 Laser Power. Green when laser output is OK. Dark when laser fails.
D2 RF Level. Red if RF level is too high, Yellow if RF level is too low and Green if RF level is
within normal limits.
D3 LNB Voltage indicator. Red or Green to indicate +13 Volts or +17 Volts. (Note: The LED
actually switch color at a threshold of +15 Volts.)
D4 22kHz indicator. Red or Green to indicate 22kHz is ON or OFF. (Note: This feature
ONLY works with the OTAPS power supply.