Ohio Steel 4048P-ATV 12.5 Cu Ft Poly ATV Cart - Manual (Page 2)

18
17
15
16
20
20
23
3
21
25
22
23
21
19
14
Step 1.
Attach latch (15) to latch post on hitch (3) using hex bolt (17) and lock nut (18).
Step 2.
Attach latch spring (16) to latch post on hitch (3) and latch (14).
Step 3.
Attach hitch coupler (25) to hitch coupler plate (24).
Secure with hex bolt (20), lock washer (22)
and hex nut (23).
Step 4.
Attach hitch coupler assembly (24)
to hitch bar. Insert hex
bolt (20) through flat
washer (21), hitch
coupler plate(24),
hitch bar (3), flat
washer (21), lock
washer (22), and
hex nut (23).
Repeat for second
hole and tighten bolts.
24
22
7
8
9
7
8
9
2
22
23
Safety Instructions
Read user guide before assembly or operation •
of this utility cart. •
Read owners manual to ATV or lawn tractor •
before use. Operational use may depend •
on vehicles. •
Always check hitch coupling is attached properly •
before use. •
Do not carry passengers in cart. •
Do not tow cart on public roads. •
Do not tow cart at high speeds. •
Cart is not designed to be pulled by cars and trucks. •
Never exceed load capacity - 1000 lbs. When •
operating on slopes, use lowest ground speed and •
limit load to 200 lbs. •
Reduce speed when driving over rough terrain. •
Reduce speed when towing heavy loads. •
Braking distance and handling may change while •
towing cart. •
Avoid sudden turns or maneuvers while towing cart. •
Operate up and down slopes, never across the face. •
Distribute load evenly to prevent loss of control. •
Maintenance
Check tire pressure regularly. •
Periodically check all bolts. •
Keep cart clean to prevent rust. •
Store inside a clean dry area. •
Tools Required
Wrenches and or sockets •
7/16", 1/2" and 9/16" •
Pliers •
Large blade screwdriver •
- 2 - - 3 -
5
1
4
Step 5.
Loosely attach axle holders (4) to
under carriage (5) using hex
bolt (20), lock washer (22),
and hex nut (23). Do not tighten
until step 8.
Step 6.
Loosely attach axle holder assembly
to body (1) using hex bolt (7),
lock washer (8) and hex nut (9).
Step 7.
Loosely attach front support (2) to
body (1) using hex bolt (7),
lock washer (8) and hex nut (9).
12
20
4
Step 8.
Slide axle (10) through axle holders (4)
and hitch assembly (3) and center.
Tighten bolts from step 5 and 6.
Step 9.
On both sides, slide on an axle
washer (12), axle spacer (13), wheel (6),
and axle washer (12). Insert cotter
pin (11) into axle (10)
and bent open
ends outward.
Step 10.
Attach safety
pin (19) on to
latch to lock hitch
bar (3) in place.
13
3
6
11
4
12
19
10
Load Weights
Note Max Capacity 1000lbs •
Weight pounds per cubic foot
Dry - Wet
Dirt 70 - 110 lbs
Sand 90 - 120 lbs
Gravel 100 - 125 lbs