Ohio Steel 3460H-ATV 20 Cu Ft Steel ATV Cart - Manual (Page 2)

FRONT SUPPORT
WELDMENT
3/8" KEPS NUT
3/8" HEX BOLT
FRONT SUPPORT
BACKING PLATE
1. Attach front support and front support
backing plate to cart body as shown with
three 3/8" x 3/4" hex head bolts and
3/8" keps nuts.
4
17
STEP 1.
AXLE HOLDER
PLATES
3/8" HEX BOLT
3/8" KEPS NUT
2. Loosely attach the four axle holder plates with the
3/8"x 3/4" hex head bolts provided. NOTE: these bolts
will be tightened after axle and wheels are installed in
a later step.
18
17
5
STEP 2.
AXLE
DRAWBAR
3. Center drawbar tube between axle holder plates and
insert axle, making sure to center axle so that wheels
can be put on in the next step.
7
12
18
3
14
8
15
13
STEP 3.
COTTER PIN
TIRE
AXLE SPACER
AXLE WASHER
COTTER PIN
AXLE WASHER
AXLE SPACER
4. Slide axle washer and axle spacer over each side
of axle as shown. Add wheels making sure valve stem
faces out. Insert cotter pin in axle and lock in place by
spreading ends. Turn cart upright and add tailgate.
13
15
14
STEP 4.
SAFETY INSTRUCTION
MAINTENANCE
CHECK TIRE PRESSURE REGULARLY.
PERIODICALLY CHECK ALL BOLTS.
KEEP CART CLEAN TO PREVENT RUST.
STORE INSIDE A CLEAN DRY AREA.
DO NOT CARRY PASSENGERS IN CART.
DO NOT TOW CART ON PUBLIC ROADS.
NEVER EXCEED LOAD CAPACITY - 1500LBS.
AVOID SUDDEN TURNS OR MANEUVERS.
WHEN OPERATING ON SLOPES, USE LOWEST
GROUND SPEED AND LIMIT LOAD TO 200LBS.
OPERATE UP AND DOWN SLOPES, NEVER
ACROSS THE FACE.
TOOLS REQUIRED
7/16" WRENCH AND SOCKET
9/16" WRENCH AND SOCKET
PLIERS