Ohio Steel 4048P 12.5 Cu Ft Poly Dump Cart - Manual (Page 2)

18
9
3
6
11 10
6
5
9
18
11
9
9
4
Step 2. Slide axle (5) through axle
holder (4) and hitch assembly (3).
Step 3. Place axle washer (9), HDPE
spacer (18), axle washer (9)and wheel
(6) onto axle.
Repeat for other side.
Step 4. Insert hairpin cotter (11) in
each end of axle (5).
Step 5. Set cart upright on wheels and
insert hitch pin (10) into hitch (3)and
secure with hairpin (11).
Step 6. To install supplied tool holders.
We recommend you measure the
spacing by attaching holders to the tool
you intend to use with cart. Mark
locations on cart body, and drill 3/16"
hole. Secure with hardware provided.
11
TOOLS REQUIRED
Large blade screwdriver. •
1/2" wrench and/or socket. •
Electric / cordless drill. •
SAFETY INSTRUCTION
Do not carry passengers in cart. •
Do not tow cart on public roads. •
Never exceed LOAD CAPACITY of 750lbs. •
Avoid sudden turns or maneuvers. •
When operating on slopes, use lowest •
ground speed and limit load to 200lbs.
Operate up and down slopes, never •
across the face.
MAINTENANCE
Check tire pressure regularly, 30psi. •
Periodically check all nuts & bolts for tightness. •
Grease wheel at axle for longer life. •
Keep cart clean and dry to prevent rust. •
When not using, store inside a clean dry area. •
Increase capacity. Divide / segregate loads.
4
1
2
7
8
Step 1. Secure front support (2) and axle holder (4) to body (1) as shown.
Create flat work space. Create your own.
Cart configurations you can make with standard lumber.
REF. NO. AMT. DESCRIPTION
1 1 Body
2 1 Front Support
3 1 Hitch Assembly
4 1 Axle Holder
5 1 Axle #1
6 2 Wheel 15 X 6.00 - 6
7 12 5/16"-18 x 1-1/2" Hex Head Bolt
8 12 5/16"-18 Keps Nut
9 4 3/4" Axle Washer
10 1 Hitch Pin
11 3 Hairpin Cotter
12 2 3/8"-16 Lock Nut
14 1 Latch Bar
15 1 Latch Spring
16 1 Bolt 3/8"-16 x 4" Hex Head
17 1 Bolt 3/8"-16 X 3/4" Hex Head
18 2 HDPE Axle Spacer
19 1 Hitch Bracket
20 1 Decal
21 1 User Guide
22 1 Hardware Bag